If you're using the FLIRC, you can map your media center's functions in MyHarmony to the buttons on your remote, and most should work without any issue. We recommend the FLIRC, though any generic USB receiver will probably work. Plug your receiver into your media center and make sure it's within view of your sitting position, so you can point your remote in its general direction.įrom there, you can map the buttons on your remote just like any other device in MyHarmony. You just need to know a few simple things.įirst, you'll need a USB infrared receiver for your media PC. How to Control Your PC with Infrared (Available on All Harmony Remotes)Ĭontrolling your PC with infrared isn't that different from setting up your Harmony remote with any other device. The closer you follow these instructions to the letter, and in the proper order, the less chance you have of running into a problem. While Logitech makes some great hardware, their software is not very good, and things can go wonky and get confusing very easily (especially when it comes to remotes with the Harmony Hub). NOTE: If you can, try to follow these instructions as closely as possible. Related: How to Control Your Entire Home Theater with a Logitech Harmony Remote If you haven't, check out our guide to getting started with Harmony first. This guide assumes you've already become somewhat familiar with your remote and the MyHarmony software, and that you've set it up with your other devices. In this guide, I'll discuss how to set up each method, and how I use both in tandem for the best of both worlds. I actually use a combination of both for my PC, to make up for each method's inadequacies. But it's more responsive than infrared, in my experience. On some PCs, it may not even be able to wake your computer from sleep. ![]() You'll need a cheap Bluetooth receiver (or a computer that already has one built-in), and it isn't quite as versatile. Bluetooth: If you have a Harmony Hub-supported remote, you can also control your PC with Bluetooth.Infrared can have a bit of lag on some systems, however (though some will be fine). ![]() You'll need a USB infrared receiver, which is cheap, and if you have a non-Harmony Hub remote, you'll need to point the remote at your media center to control it. Infrared: All Harmony remotes support this option, and it's the most versatile with the least amount of fiddling.They should already be recorded, but it doesn't work before or after. Below is the log.Depending on the remote you have, you have a few options when it comes to controlling your media PC. Just mapped the stop button on my Harmony to Esc and space bar to pause. A firmware downgrade could probably do the job (but I have no access to older firmware, and means to install it), but other solutions are of course also very welcome. I even tried an old trick with Zadig software, but that did not work either.Ī solution would be much appreciated, as a working flirc is really a great device. So, in one instance a wonderful device became completely useless. I re-installed software, drivers, and tested everything on another pc, but without any result. Before the crash, a Flirc device was listed (as far as I know) The system management of Windows 10 showed a USB-device, with an error message: 'could not start'. So, I started the software, and was asked to update the software v3.25.0 (from 3.24.3) the firmware was also upgraded.Īfter that, the flirc did not respond to any keystroke from my remote. ![]() I was close to a perfectly working system, but had to make two small adjustments. I use the flirc with a Logitech Harmony One remote, to control my (Windows 10) media-pc with Kodi. About a week ago I bought the Flirc usb device, and it worked flawlessly until today.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |